Always make sure the memory is stable to prevent damage. Once again, perform tests after every change. At the first sign of instability in Memtest86+, revert to your previous configuration and stop there.Īfter you set the desired voltage, you can continue tweaking the timing in small increments.After the reboot, perform a memory test and make sure it is stable.Save the settings and reboot the computer.Navigate to the ‘tweaker’ and choose the manual option.After each change, you will perform another memory test, which will tell you whether to stop or to keep making changes. Manual RAM overclocking will start with your previously obtained XMP settings. When the computer boots, perform a memory test in Memtest86+ and make sure everything is stable.Save your changes and reboot the computer.Select your desired settings from the drop-down menu. Navigate through BIOS to find the ‘tweaker.’.Open the SPD tab and write down the XMP settings that you want to establish.You will need that in case you want to undo your changes. ![]() First, open CPU-Z, choose the memory tab, and write down the RAM’s current frequency and timing.My bus clock is 99.8 so my values are not rounded evenly but with the example I have above, I got 1900:1900. All you should be concerned when reading CPU-Z is: Does NB Frequency DRAM Frequency If so, you are in 1:1 ratio. ![]() We recommend this method, as it’s the most stable and user-friendly. FSB:dRAM says 3:57 but that doesnt matter (to my knowledge) for this topic. ![]() XMP (extreme memory profiles) is a set of prearranged, tested, and validated overclocking settings that can be used for safe and automatic configuration of RAM. That should return your BIOS to factory settings and allow your computer to boot normally. My modules are 'G.Skill DDR4-3200 16GB (8GBx2) Dual Channel Trident Z F4-3200C16D-16GTZB' if that has any bearing on it. It’s unlikely that you’ll run into serious problems if you take this slow and careful, but if you do, consult your motherboard manual and clear the CMOS on your motherboard. I was checking to in CPU-Z and noticed in the Memory tab that there is a line 'Uncore Frequency' which is showing 4000-4100MHz. Additionally, most DDR4 kits start being sold at around 2133 or 2400 MHz rather than 1600 MHz, which is still within the range of DDR3 speeds. If a memory test ever displays warnings after you make a change, return everything to its previous settings. Technically the official DDR4 spec caps out at 3600 MHz, but even today (in 2022), the limits of DDR4 kits are regularly being pushed to even higher frequencies.
0 Comments
Leave a Reply. |